PRODUCT INSTALLATION MANUAL
DO13 SELF SERVE OLIVE
_________________________________________________________________________________________________________________________
Page 24
Hussmann
Appendixes
Appendix 1
Wiring diagrams
–
Supplied with each case.
Appendix 2
Product Engineering Datasheet
–
Supplied with each case.
Appendix 3
Setting Table
–
Supplied with each case.
Appendix 4
Attaching case ends
Case ends are normally fitted in the factory; however, they occasionally need to be attached to a case on-site. Use this
procedure when an end attaches to a single case and when it is common to two cases.
Ensure that correct and appropriate manual handling techniques are applied when fitting a patch end.
Cases must be sealed before attaching case ends. To seal cases, refer to sealing case joins on page 9.
To attach a case end
1. Carefully run a knife around the inside rim of the end trim, taking care not to scratch the case end surface, and
remove the case end membrane.
2. To assist in screwing in the Lag screws, drill a 6mm hole in the mounting positions shown, using the 10mm diameter
fixing hole location. Ensure you do not drill completely through the End. see Fig (19)
Fig (19) Drill hole locations
(Inside Right hand End shown)
FRONT OF CASE
Fixing Holes
