Husqvarna Wacker Neuson CRT60-74LX, Руководство оператора

Страница: 72 / 136

wc_tx004561gb.fm
72
Maintenance CRT60-74LX
Continued from the previous page.
6. Remove the container.
Adding
hydraulic oil
After the used hydraulic oil has been drained, refill the system. To do so:
1. Reconnect the hydraulic hose (f) .
2. Remove the hydraulic hose (y) .
3. Remove the fitting (x) .
4. Add fresh hydraulic oil to the machine through the fill port (a) . See Technical
Data for quantity and type.
5. Reconnect the fitting (x) and the hydraulic hose (y) to the fill port.
6. Fill the overflow bottle to the level indicator on the side of the bottle.
Distributing
the hydraulic
oil
1. Start the engine and allow it to warm up for a few minutes.
NOTICE: Do not operate the rotors for more than five minutes or at high speeds
when there is no resistance to blade rotation. Doing so may damage the motors.
2. Operate the rotors at a slow rate of speed for approximately five minutes.
3. Raise the wheels to lower the trowel.
4. Operate the trowel—using all hydraulic functions—for 5–10 minutes. Add
hydraulic oil if necessary.
5. Stop the engine. Allow the machine to cool.
6. Check the hydraulic oil level in the overflow bottle. Add oil as needed.
WARNING
Most used hydraulic oil contains small amounts of materials that can cause cancer
and other health problems if inhaled, ingested, or left in contact with skin for pro-
longed periods of time.
► Take steps to avoid inhaling or ingesting used hydraulic oil.
► Wash skin thoroughly after exposure to used hydraulic oil.
wc_gr012742
a
x
y
f