Husqvarna W50P, Руководство оператора

Страница: 15 / 224

a) Remove the drain plug (A).
A
b) Flush the pump chamber with clean water.
c) Let the water drain from the pump chamber.
d) Install the drain plug.
• Clean the product. Refer to To clean the product on
page 13
.
• Lubricate the controls with a silicone spray lubricant.
• Examine the product for corrosion. Speak to a
servicing dealer if it is necessary.
• Add the fuel stabilizer to the fuel tank to prevent
deterioration. Refer to To add a fuel stabilizer to the
fuel on page 15 .
• Put a dust cover on the product for protection.
• Put the product in a location with a good airflow and
away from flames and sparks.
• If it is possible, do not put the product in a location
with high humidity.
To add a fuel stabilizer to the fuel
To keep the fuel in good condition for a period of 3
months, it is necessary to add a fuel stabilizer.
1. Put the fuel stabilizer in a fuel container with fresh
fuel.
2. Fill the fresh fuel with fuel stabilizer into the fuel tank
of the product. Refer to
To fill fuel on page 8
.
3. Fill the pump chamber with water. Refer to To fill the
product with water on page 8
.
4. Start the engine and let the product operate for 10
minutes. This is to make sure that the fuel with the
fuel stabilizer has replaced the fuel without a fuel
stabilizer.
5. Stop the engine and move the fuel valve lever to the
OFF position. Refer to To stop the product on page
10
.
6. Drain the water from the pump chamber.
To prepare your product for long-term
storage
The instructions that follow are applicable to a storage
period longer than 90 days.
1. Do the steps given in
To prepare the product for
short-term storage on page 14
.
2. Replace the engine oil. Refer to
To replace the
engine oil on page 12 .
3. Apply oil to the cylinder. Refer to To apply oil to the
cylinder on page 16
.
4. Drain the fuel tank and carburetor. Refer to To drain
the fuel tank and carburetor on page 15
.
To drain the fuel tank and carburetor
1. Put an applicable fuel container below the
carburetor. Use a funnel to prevent fuel leakage.
2. Move the fuel valve lever (A) to the OFF position.
A
3. Turn the carburetor drain bolt (B) 1-2 turns
counterclockwise.
B
4. Let the fuel drain from the carburetor.
5. Tighten the carburetor drain plug.
6. Remove the sediment cup.
1421 - 004 - 09.07.2020 15