Husqvarna W50P, Руководство оператора

Страница: 13 / 224

1. Remove the star nut (A), the air filter cover (B), the
wing nut (C) and the air filter (D).
A
B
D
C
2. Examine the air filter for dirt and damage.
3. Clean the air filter if it is necessary. Do the steps that
follow.
a) Clean the air filter in warm soap water.
b) Let the air filter become dry.
c) Put the air filter in engine oil. Rub the air filter to
supply the engine oil equally across the air filter.
d) Compress the air filter to remove unwanted oil
from the air filter.
4. Clean the area around the air filter and the air filter
cover. Make sure that no unwanted particles go into
the air duct that is connected to the carburetor.
5. Install the air filter, the wing nut, the air filter cover
and the star nut.
To clean the product
WARNING:
Let the engine become
cool before you clean the product.
1. Clean the product parts by hand.
CAUTION:
Do not let water go into
the air filter, air filter cover, the muffler or
the controls. This can cause damage to
the product.
2. Use a cloth to dry the surface of the product.
3. Fill the pump chamber with water. Refer to
To fill the
product with water on page 8 .
Troubleshooting
The engine does not start
Cause Solution
The fuel valve lever is set to the OFF position. Move the fuel valve lever to the ON position.
The choke is open. Close the choke.
The ON/OFF switch is set to the OFF position. Set the ON/OFF switch to the ON position.
There is no fuel in the fuel tank. Fill fuel.
There is unsatisfactory fuel in the fuel tank. Drain the fuel tank and the carburetor. Refer to To drain
the fuel tank and carburetor on page 15
. Fill with clean
fuel.
No fuel stabilizer has been added or the fuel tank has not
been drained before storage.
The spark plug is damaged. Do a check of the electrode gap or replace the spark
plug.
The spark plug is wet from fuel. Remove the spark plug and let it dry. Install the spark
plug.
CAUTION:
Speak to an approved
servicing dealer if the problem stays.
1421 - 004 - 09.07.2020 13