Husqvarna Viking Amber Air S 400, Руководство пользователя

Страница: 15 / 44

K L
M
O
N
G
H
I J
GETTING READY TO SEW – 15
Set the Threading/Sewing switch to “Threading” position
(G) by turning it to the right.
Turn the handwheel slowly toward you until the mark on
the wheel matches the mark on the cover (H). The hand
wheel will click and is locked in threading position.
Turn the looper selection lever to the right (I) to activate
the lower looper threading.
Using the tweezers, insert the end of the thread 2 cm or
more into the lower looper threading hole (J).
Note:
• Trim the thread end so that it can be inserted into the threading
hole smoothly.
• If threading special threads, such as wooly nylon, etc., refer to
pages 18-19.
Raise the looper threader lever (K) until it clicks into place.
Lower it again until it knocks into place.
Make sure that the thread comes out from the hole of the
lower looper tip (L). The thread shall run in front of the
upper looper threading pipe (M). If the thread comes out
behind the pipe, use the tweezers to position the thread in
front of the threading pipe.
If the thread does not come out from the hole, follow the
procedure from step ”J” again.
Set the Threading/Sewing switch (G) to “Sewing” position
(N).
Pull 4˝ (10 cm) of the thread under the toe of the foot, and
back between the presser fot foot and the upper cutter (O).
Close the front cover and lower the presser foot lifter.