Husqvarna TS 60, Руководство оператора

Страница: 13 / 80

English
– 13
OPERATING
Electrical safety
• Check that the mains voltage corresponds with that stated
on the rating plate on the machine.
• Inspection and/or maintenance should be carried out with
the motor switched off and the plug disconnected.
• Always shut down the machine before disconnecting the
power plug.
• Never drag the machine by means of the cord and never
pull out the plug by pulling the cord. Hold the plug to
disconnect the power cord.
• Never use the machine if any cable or plug is damaged,
but hand it in to an authorized service workshop for repair.
• Always connect the machine through an ground fault
circuit interrupter with personal protection, i.e. an ground
fault circuit interrupter that trips at an ground fault of 30
mA.
Grounding instructions
• The machine is equipped with a grounded cord and plug
and should always be connected to a grounded outlet.
This reduces the risk of electric shock in the event of
malfunction.
Extension cords and cables
• The marking on the extension cable must be the same or
higher than the value stated on the machine’s rating plate.
• Use grounded extension cables.
• When operating a power tool outdoors, use an
extension cord suitable for outdoor use.
Use of a cord
suitable for outdoor use reduces the risk of electric shock.
• Keep the connection to the extension cord dry and off the
ground.
• Keep cable away from heat, oil, sharp edges or moving
parts. Damaged or entangled cable increase the risk of
electric shock.
• Check that the cord and extension cord are intact and in
good condition. Never use the machine if any cable or plug
is damaged, but hand it in to an authorized service
workshop for repair.
• To avoid overheating do not use the extension cord while
it is rolled up.
• When using an extension cable, use only certified
extension cables with sufficient reach. For more
information, see "Recommended cable dimensions" in the
"Technical data" section.
Work safety
Work area safety
• Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
• People and animals can distract you causing you to lose
control of the machine. For this reason, always remain
concentrated and focused on the task.
• Do not use the machine in bad weather, such as dense
fog, heavy rain, strong wind, intense cold, etc.
• Never start to work with the machine before the working
area is clear and you have a firm foothold.
• Do not operate power tools in explosive atmospheres,
such as in the presence of flammable liquids, gases
or dust.
Power tools create sparks which may ignite the
dust or fumes.
!
WARNING! There is always a risk of shocks
from electrically powered machines. Avoid
unfavourable weather conditions and body
contact with lightning conductors and metal
objects. Always follow the instructions in the
Operator’s manual to avoid damage.
Never connect the machine to a outlet if plug
or cord is damaged.
!
WARNING! When cleaning the machine,
make sure to avoid water entering the
electrical system and the motor unit. Water
can cause damage to the machine or short
circuit.
!
WARNING! Improper connection can result
in the risk of electric shock. Contact a
qualified electrician if in doubt as to whether
the appliance is properly grounded.
Do not modify the plug. If it will not fit the
outlet have a proper outlet installed by a
qualified electrician. Make sure local
regulations and ordinances are followed.
If the grounding instructions are not fully
understood contact a qualified electrician.