Husqvarna Solar Mower, Руководство оператора, Страница: 9 / 16

English –
7
USE
Start and stop
!
WARNING!
Keep hands and feet away from the rotating
blades. Never place your hands or feet close
to or under the cutting deck’s cover when the
motor is running.
Starting the Solar Mower
1. If the Solar Mower is new or has been stored for a long
time, the batteries must be charged before starting. Charge
the batteries by placing the Solar Mower in daylight for
about one hour with the rear solar panel folded down and
the power switch off.
2. Fold up the rear solar panel, switch on the power switch
and a long beep should be heard.
3. Enter your personal code,
*
code # . On delivery the code
is
*
0000 # , see
chapter “Settings”.
4. Fold down the rear solar panel. The Solar Mower will start
after approx. 10 seconds, if the battery is sufficiently
charged. Otherwise it switches into charging mode (two
beeps every tenth second) and starts as soon as the
battery has been charged sufficiently.
Stopping the Solar Mower
• Stop the Solar Mower by folding up the rear solar panel. Enter
the first digit of your personal code to switch off the theft
alarm. The long beep confirms that the cutting disc has
stopped. You have 6 seconds before the theft alarm starts.
• Reset the Solar Mower by folding down the rear solar panel
again.
• Always switch off the power switch if you intend to carry out
any maintenance on the Solar Mower or if you intend to move
it outside of the mowing area.
Latch
!
WARNING!
Read carefully through the safety regulations
in this Operator’s Manual before you start the
Solar Mower.
Charging the battery
When the Solar Mower’s battery is discharged, for example, on
delivery or after a long period of storage, it needs to be charged
before the Solar Mower can be started. Follow the start-up
sequence in this Operator’s Manual. You do not need to wait
until the battery is charged when the Solar Mower has only
been switched off temporarily.
Adjusting the cutting height
The cutting height can be adjusted between 3 and 9 cm.
• Switch off the Solar Mower by folding up the rear solar panel,
enter the first digit of your personal code and switch off the
power switch.
• Place something that is higher than the rear solar panel’s
edge under the Solar Mower when it is turned upside down.
This will prevent the edge from being damaged.
• Undo locking knobs to release the cutting deck. Move the
entire cutting deck upwards or downwards to give the desired
cutting height (3-9 cm). Then tighten the locking knobs one at
a time.
STOP
To prevent the rear solar panel from being lifted up in strong
wind the Solar Mower is fitted with a latch.