Husqvarna Rider Pro 18 AWD, Руководство по ремонту

Страница: 42 / 133

English-
40
REPAIR INSTRUCTIONS
Fuel Tank
Removal
1. Place a suitable container to collect the petrol.
The tank holds about 17 litres (4.5 US Gal).
2. Empty the petrol tank by removing the hose
from the connector under the tank. If you do
not wish to empty the tank, you can pinch the
hose with lockable welding pliers and then
remove the hose and hose clamp from the
fuel filter's lower connector. You must then be
sure to keep the hose opening higher than the
fuel level in the tank.
3. Remove the three screws that fix the tank to
the bracket. A screw is hidden on the front of
the bracket. Lower the tank and pull out the
hose through the frame of the machine (if it
has been loosened by the fuel filter).
Fitting
1. It is easier to work if you empty the tank
before fitting. Insert the hose into place and
attach it to the fuel filter with the hose clamp.
Make sure that the hose cannot be chafed or
rubbed.
2. Place the tank in place on the bracket and
attach it with the screws and washers.
3. Fit the fuel hose and the hose clamp to the
connector under the tank as required. Fill with
petrol and check that there are no leaks.
Pulse Air Valve Intake Filter
Cleaning the pulse air filter
1. Fold the seat back, open the engine cover.
2. Loosen the four snap catches, remove the
cover, and remove the filter.
3. Blow the filter clean with compressed air.
Replace the filter if it is damaged or cannot be
blown clean.
Place the filter back in the cover and fasten the
cover with the snap catches. Replace the engine
cover.
WARNING!
Petrol is highly flammable and
environmentally hazardous.
Exercise caution to avoid fire and
spillage.
!
8009-399
The fuel tank fixture
IMPORTANT INFORMATION
Overly long screws can damage the tank
and cause fuel leakage.
Only use approved screws specified in the
spare parts catalogue.
8009-342
Pulse air valve filter