Husqvarna Rider 318, Руководство оператора, Страница: 16 / 132

Maintenance Daily maintenance
before operation
Maintenance interval
in hours
25 50 100 200
Make sure that nuts and screws are tightened *
Make sure that there are no fuel or oil leaks *
Clean as given in To clean the product on page 17 X
Clean the inner surface of the cutting deck, around the blades X
Clean around the muffler X
Make sure that the cold air intake of the engine is not blocked X
Make sure that the safety devices are not defective X
Examine and do a test of the brakes *
Do a check of the engine oil level X
Do a check of the oil level in the transmission X
Do a check of the steering wires X
Examine the blades in the cutting deck X
Clean the cutting deck, below the belt covers and below the cutting
deck
X
Make sure that the tire pressure is correct X X
Do a check of the parking brake X
Change the engine oil X X
Change the oil filter X X
Clean the air filter X
Change the air filter X
Change the fuel filter X
Do a check of the parallelism of the cutting deck X X
Lubricate the belt adjuster. X X
Examine and adjust the steering wires O O
Examine the muffler and heat deflector O
Examine the cutting deck for damages O
Change the spark plug O
Adjust the parking brake. O
Do a check of and adjust the throttle wire O
Clean the cooling fins on the engine and the transmission O
Clean the engine and the transmission O
Do a check of/adjust front and rear wheel speed, Rider 320 AWD
model only
O O
Do a check of the belts O O
16 246 - 001 - 04.10.2017