Husqvarna R 316TX, Руководство оператора

Страница: 29 / 164

WARNING:
If you spill engine oil on
your body, clean with soap and water.
1. Put a container below the oil drain plug on the left
side of the engine.
2. Remove the dipstick.
3. Remove the oil drain plug.
4. Let the oil run out into the container.
5. Attach the oil drain plug and tighten it.
6. Turn the oil filter counterclockwise to remove it.
7. Lightly lubricate the rubber seal on the new oil filter
with new oil.
8. To attach the oil filter, turn it clockwise by hand until
the rubber seal is in position, then tighten a half turn
more.
9. Fill with new oil as given in
To do a check of the
engine oil level on page 28 .
-20°C -10°C 20°C 10°C 30°C 40°C 0°C
-4°F -14°F 68°F 50°F 86°F 104°F 32°F
SAE40
SAE30
SAE10W-40
SAE10W-30
SAE5W-20
10. Start the engine and let it idle for 3 minutes.
11. Stop the engine and make sure that the oil filter does
not leak.
12. Fill with oil to compensate for the oil held in the new
oil filter.
Note:
For safe disposal of used engine oil, refer to
Disposal on page 34
.
To do a check of the transmission oil
level
1. Remove the two screws, one on each side, and lift
off the transmission cover.
2. Make sure that the oil level in the transmission oil
tank is between the two horizontal lines on the tank.
3. Fill with engine oil if the oil level is below the lower
line, but do not fill above the top line.
Note:
Refer to
Technical data on page 35
for
recommended oil for R 316TX and R 316TX AWD, R
316TsX AWD.
To lubricate the belt adjuster
The belt adjuster must be lubricated regularly with a
good quality molybdenum disulphide grease.
844 - 007 - 03.11.2021 29