Husqvarna R 316TX, Руководство оператора

Страница: 19 / 164

3. Put the strap through the rail bracket (B) on the
opposite side.
4. Use the rail brackets to attach the load with straps.
CAUTION:
Do not overload the
rails. Refer to Technical data on page
35 .
Maintenance
Introduction
WARNING:
Before you do any
maintenance work you must read and
understand the safety chapter.
Maintenance schedule
1. PREPARE THE PRODUCT First
servicing
Maintenance interval
in hours
50 100 200
Do a check of the battery. O
Do a check of the blades. O
Do a check of and clean hydraulic hoses and couplings. Replace if necessary. O
Do a check of the belts and pulleys. O O
Do a check of the steering chain of the inner side of the frame tunnel. O
Do an inspection, lubricate and adjust all wires. O
Make sure that the tire pressure is correct. Refer to Tire pressure on page 25 . O O
Make sure that all screws and nuts are tightened with the correct torque. O
Lubricate the operators seat. O
Lubricate all chains. O
Lubricate the wheels and blade bearings on the cutting deck. O O
Lubricate the pedals on the inner side of the frame tunnel. O
Lubricate the belt tensioner. O
Remove the drive wheels and grease the axels. O
2. ENGINE First
servicing
Maintenance interval
in hours
50 100 200
Do a check of the fuel hose. Replace if it is necessary. O
Replace the fuel filter. Refer to
To replace the fuel filter on page 23
. O
Replace the air filter. Refer to
To clean and change the air filter on page 23
. Clean O
Do an inspection of the cooling fins on the hydrostatic transmission. O
Clean the engine and the hydrostatic transmission. O
Do a check of the muffler and the heat deflector. O O
844 - 007 - 03.11.2021 19