Husqvarna Pressure Washer, Руководство оператора

Страница: 14 / 60

14 www.usa.husqvarna.com
9. Move throttle control lever ( A ) to “ Fast ” position,
shown on engine as a rabbit .
10. Move choke lever ( B ) to “ Choke ” position.
NOTICE
For a warm engine, be sure the choke lever is in
the “ Run ” position.
NOTICE
Before starting the pressure washer, be sure you
are wearing safety goggles as described below.
11A. For electric starting , turn and hold key in start switch to
start ( ) position until pressure washer starts. To
prolong the life of starter components, DO NOT hold key
in start (
) position for more than 15 seconds, and
pause for at least 1 minute between starting attempts.
•
If engine starts, proceed to step 14.
• If engine fails to start, proceed to step 12.
NOTICE
If battery is discharged, use manual starting
instructions.
11B. For manual starting , position yourself as
recommended below, grasp recoil handle and pull
slowly until you feel some resistance. Then pull rapidly
to start engine. Return starter grip handle slowly. DO
NOT let rope “snap back” against starter.
•
If engine starts, proceed to step 14.
• If engine fails to start, proceed to step 12.
NOTICE
After each starting attempt, where engine fails to
run, always point gun in safe direction, press red button and
squeeze spray gun trigger to release high pressure.
12. Move choke lever half way, pull recoil handle twice or
turn and hold key in start switch to start ( ) position
as described in step 11A.
•
If engine fails to start, repeat steps 10 thru 11.
13. If engine fails to start after six pulls, move choke lever
to “ Run ” position, and repeat step 11.
14. When engine starts, slowly move choke lever to “ Run ”
position, as engine warms. If engine falters, move choke
lever to “
Choke ” position, then to “ Run ” position.
NOTICE
Always keep the throttle control lever in the “Fast”
position when operating the pressure washer.
B
WARNING Risk of eye injury.
Spray could splash back or propel objects
resulting in serious injury.
• Always wear indirect vented (chemical splash) safety goggles
marked to comply with ANSI Z87.1 when using or in vicinity of
this equipment.
• NEVER substitute safety glasses or dry-condition goggles for
indirect vented safety goggles.
WARNING Starter cord kickback (rapid retraction) will
pull hand and arm toward engine faster than you
can let go which could cause broken bones,
fractures, bruises, or sprains resulting in serious
injury.
• NEVER pull starter cord without first relieving spray gun
pressure.
• When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
• After each starting attempt, where engine fails to run, always
point spray gun in safe direction, press red button and squeeze
spray gun trigger to release high pressure.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
A
Not
for
Reproduction