Husqvarna PP 492, Руководство оператора

Страница: 14 / 84

• To stop the cutting equipment, turn the dial that
controls the speed counterclockwise to its 0 position.
OK
ON/OFF
0
For more instructions in sawing procedures, refer to the
manual supplied with the wall saw.
To stop the product
WARNING: Always close the water supply to
the product when it is not connected to the
power supply.
1. To stop the blade, turn the dial that controls the
speed counterclockwise to its 0 position.
OK
ON/OFF
0
2. Close the water supply to the product. If the water
coolant is set to "AUTO", the water supply will stop
automatically.
3. Stop the remote control unit, push the "ON/OFF"
button.
OK
ON/OFF
0
4. Push the emergency stop button to stop the product.
Maintenance
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Daily maintenance
WARNING: Disconnect the product from the
power supply and wait minimum 5 minutes
before you start the maintenance.
CAUTION: Do not use a high pressure
washer to clean the product. The high
pressure can cause damage to the seals
and cause water and dirt to come into the
product.
• Do a check of the safety equipment. Make sure that
it is not damaged. Refer to
Safety devices on the
product on page 6 .
• Make sure that the power cord and the extension
cable are in good condition and not damaged.
• Make sure that the water hose and water couplings
are in good condition and not damaged.
14 967 - 001 - 04.02.2020