Husqvarna NUDA 900 2012, Руководство по ремонту

Страница: 265 / 363

L1.7
NUDA 900 2013 - NUDA 900 R 2013
H12025
1
2
3
4
5
6
7
H12026
3
4
H12027
3
H12028
2
8
H12029
C
C
2
4
11
11
10
9
Workshop Manual Ed. 11-2011
BRAKES
Removing the braking system
Removing the ABS unit
Remove the tank, the filter box and the rear wheel as described in the relative
paragraphs.
The new ABS unit is supplied pre-filled with fluid.
Brake fluid is highly corrosive and may cause skin irritation; place
absorbent paper around the ABS unit to absorb any spilled fluid.
- Drain the fluid from the front and rear brake systems as described in the
relative paragraphs.
- Undo the three lines (1), leaving the front line (2) connected.
- Use a screwdriver to detach the connector (3) on the ABS unit (4).
- Open the clamp (5), cut the cable tie (6) and remove the immobiliser connec -
tor (7).
- Undo the line (2) from the distributor (8).
- Undo the two screws (9) and remove the ABS unit (4) complete with line (2)
and mount (10).
- Undo the line (2) and the screws (11) to remove the ABS unit.
- Fit the new ABS unit on the mount (10), remove the cap relative to the front
feed line and reconnect the line (2), replacing the seal washer.
- Refit the ABS with the relative bracket on the motorcycle, tightening all the
screws (9) to the correct tightening torques, then remove the protective caps
and reconnect the lines (1), replacing the seal washers and ensuring that
each line is reinstalled in exactly the same position as before.
- Reconnect the electric power connector.
- Fill the system with fluid and bleed as described in the relative paragraph.
- Reassemble all parts, in the reverse order compared to disassembly.