Husqvarna K970 SmartGuard, Руководство по ремонту, Страница: 30 / 76

6.2.10 To assemble the ignition unit
1. Align the magnet on the flywheel with the ignition
unit.
0,3
mm
2. Put the air clearance gauge (0.01 in./0.3 mm)
against the magnets. Refer to
Servicing tools
overview on page 12.
3. Put the new ignition unit in position. Push it against
the air clearance gauge while you tighten the
screws. Tighten the screws with a torque of 10–12
Nm.
6.3 Flywheel
6.3.1 To remove the flywheel
Use a Husqvarna flywheel puller. Refer to Servicing
tools overview on page 12.
1. Remove the starter, refer to
To remove the starter
on page 15.
2. Remove the lower air duct, refer to
To remove the
air duct on page 18.
3. Loosen the springs and put the starter pawls in their
outer positions.
4. Put a 13 mm socket on the center screw of the
flywheel.
5. Attach the flywheel puller on the socket with the
screw that is supplied with the flywheel puller.
6. Hold the handle of the flywheel puller to lock the
flywheel. Remove the nut and the washer.
30 - Repair and servicing 1451 - 001 - 02.04.2020