Husqvarna K 970 Ring, Руководство оператора

Страница: 10 / 32

10 –
English
ASSEMBLING AND ADJUSTMENTS
Fitting the blade
• Wipe off any dirt from the surface of the blade.
• Loosen the locking nuts on the support roller cover.
• Unscrew the adjuster screws a few turns.
• Loosen the knob to offload the springs.
• Remove the four screws holding the support roller guard
using a 6 mm hex key and lift off the cover.
• Fit the blade.
• The blade has a groove (1) on one side that acts a the
guide groove for the support rollers. Ensure that the V-
shaped edge of the blade enters the drive wheel and that
the blade’s guide groove fits in the guide rollers.
• Ensure that the V-shaped edge of the blade enters the
drive wheel and that the blade’s guide groove fits in the
guide rollers. See instructions in the section "Blades”.
• Press in the guide roller if necessary, so that it climbs into
the groove on the blade.
!
WARNING! It is forbidden to reconstruct a
used blade. A used blade may be weakened.
A reconstructed blade can crack or break
into pieces and seriously injury the operator
or other persons.
!
WARNING! Check that the blade is not
damaged before fitting it on the machine.
Damaged blades can disintegrate and cause
serious personal injury.
NOTICE! Replace the drive wheel when fitting a new blade.
A worn drive wheel can result in the blade slipping and
becoming damaged.
Inadequate water flow drastically shortens the life of the
drive wheel.