Husqvarna FE 450 EU, Руководство пользователя

Страница: 49 / 117

12 SERVICE WORK ON THE CHASSIS
47
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 41)
400738-11
Main work
–
Move the handlebar to the straight-ahead position. Move the fork legs to and fro in
the direction of travel.
No play should be noticeable in the steering head bearing.
» If there is noticeable play present:
–
Adjust the play of the steering head bearing.
x
( p. 47)
–
Move the handlebar to and fro over the entire steering range.
The handlebar must be able to move easily over the entire steering range. No rest-
ing locations should be noticeable.
» If click positions are noticeable:
–
Adjust the play of the steering head bearing.
x
( p. 47)
–
Check the steering head bearing and replace if required.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 41)
12.14 Adjusting the play of the steering head bearing
x
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 41)
C00570-10
Main work
–
Loosen screws
1
. Remove screw
2
.
–
Loosen and retighten screw
3
.
Guideline
Screw, top steering head M20x1.5 12 Nm (8.9 lbf ft)
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Tighten screws
1
.
Guideline
Screw, top triple clamp M8 17 Nm (12.5 lbf ft)
–
Mount and tighten screw
2
.
Guideline
Screw, top steering stem M8 17 Nm
(12.5 lbf ft)
Loctite ® 243™
Finishing work
–
Check the steering head bearing play. ( p. 46)
–
Remove the motorcycle from the lift stand. ( p. 41)
12.15 Lubricating the steering head bearing
x
800010-10
–
Remove the lower triple clamp.
x
( p. 44)
–
Install the lower triple clamp.
x
( p. 45)