Husqvarna F2101U0, Руководство пользователя

Страница: 89 / 137

BRAKE SYSTEM 12
87
K01275-10
–
Stand the vehicle upright.
–
Remove screw cap
1
with membrane
2
and the O-ring.
M01328-10
–
Manually press the brake caliper toward the brake disc to
push back the brake piston. Ensure that brake fluid does
not flow out of the brake fluid reservoir, if necessary extract
excess.
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake pis-
ton.
–
Remove cotter pins
3
, pull out pin
4
, and remove the
brake linings.
–
Clean the brake caliper and brake caliper bracket.
M00288-10
–
Check that spring plate
5
in the brake caliper and sliding
plate
6
in the brake caliper bracket are seated properly.
Info
The arrow on the spring plate points in the direction of
rotation of the brake disc.
M01329-10
–
Insert the new brake linings, insert pin
4
, and mount the
cotter pins
3
.
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
7
is mounted on
the piston side brake lining.
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
K01274-10
–
Add brake fluid to level
A
.
Brake fluid DOT 4 / DOT 5.1 ( p. 126)
–
Mount and tighten screw cap
1
with membrane
2
and the
O-ring.
Info
Clean up overflowed or spilled brake fluid immediately
with water.