English –
9
Lubricating the flexible drive axle
Inside the edger‘s drive shaft
is a flexible drive axle. The
flexible drive axle should be
regularly lubricated after 30
hours of operation. Loosen the
two screws on the angle gear
and remove it. The flexible
drive axle is easily removed
from the shaft by taking a firm
grip on the axle end. Lubricate
the flexible drive axle over its
entire length and reinsert it in
the shaft. Turn the axle while
inserting it so that it correctly
engages in the clutch.
Replace the angle gear on the
drive axle shaft and tighten the
two screws.
MAINTENANCE
The cutting depth should be
adjusted before starting
work.
• Loosen the locking handle
(A) and rotate the guard by
moving the locking knob
forwards or backwards. If
the locking handle is moved
forwards (from the
machine) the cutting depth
is increased. If the locking
handle is moved backwards
(towards the machine) the
cutting depth is reduced.
• Adjust the cutting depth.
• Lock the locking handle.
A
WARNING!
Always bear the machine on the right side of
the body. Always wear protective glasses,
long trousers and heavy-duty shoes when
using the machine. Observe your
surroundings, ensure people and animals do
not come in the immediate vicinity or can be
hit by thrown objects. Apply full throttle
before the blade starts to work on the soil.
!
Adjusting the edger's cutting depth
Angle gear
The angle gear is filled
a sufficient quantity of grease
at the factory. However,
before using the machine you
should check that the angle
gear is filled to 3/4 with
grease. Use HUSQVARNA
special grease.
Normally, the grease does not
need to be changed except
when repairs are carried out.
Maintenance schedule
Below follows some general maintenance instructions. If you
need further information please contact your service
workshop.
Daily maintenance
1.
Check that the blade
does not rotate while
idling.
2.
Check the guard for
damage and ensure that
it is not cracked.
Replace the guard if it
has been exposed to
impact or is cracked.
3.
Check that the blade is
undamaged and not
cracked. Replace the
blade if necessary.
4.
Check that the locking
nut is tight.
2
3
4
1
Weekly
maintenance
1.
Check that the angle
gear is 3/4 filled with
grease. Fill if necessary
using special grease.
2.
The flexible drive shaft
must be lubricated after
every 30 hours in
operation or more often.
1
2
TECHNICAL DATA
Technical data
Weight, Lbs/kg
Blade length
Centre hole, blade
Speed, blade
1,6
195 mm
1" = 25,4 mm
7140 r/min
