English
– 19
OPERATING
Install and tighten blade shaft bolt and plain washer using
the blade shaft wrench while firmly holding the blade.
•
Lower the saw by pushing the Raise/lower switch on the
speed control lever downwards until the blade touches the
surface to be cut. Then move the Raise/Lower switch back
to neutral position.
•
Tighten the blade shaft bolt firmly using the blade shaft
wrench while resistance between diamond blade and
ground helps to achieve proper and final tightening.
•
Lower blade guard front and position the blade guard latch
on the blade guard front bolt. Tighten the blade guard front
bolt.
•
Always attach the front slider protection on the blade
guard. Make sure it moves up/down freely.
•
Test run the machine and check that no unusual sounds
occur. Unusual sounds are a sign of an incorrectly
mounted blade.
Install the blade guard
Inspect blade guard and locks frequently.
!
CAUTION! The touch should be smooth to
prevent damaging the blade. Use Saw
lowering speed control knob to slow down
the lowering speed. Never let the front
weight of the machine be supported by the
blade since this will damage the blade.
1
2
4
3
NOTICE! Do not operate this saw without the latch engaged
and the bolt installed. Do not use if damaged. Do not
operate this saw without the front-slider protection installed.
