Husqvarna DM400, Руководство оператора

Страница: 14 / 648

To stop the product
WARNING: The drill bit continues to rotate
for some time after the motor stops. Do not
stop the drill bit with your hands. Injuries can
occur.
1. To stop the product, set the ON/OFF switch to "0".
2. Wait until the drill bit has fully stopped.
To reset the motor overload protection
1. Stop the product. Refer to
To stop the product on
page 14 .
2. Remove the blockage from the drill bit.
3. Start the product. Refer to
To start the product on
page 12 .
To replace the drill bit
WARNING: Pull out the plug from the mains
outlet before you replace the drill bit.
Note: Only use diamond drill bits that are approved for
your product. Speak to your Husqvarna dealer for more
information.
1. Make sure that you have got a new drill bit, 2
wrenches and water resistant grease.
2. Use the wrenches to remove the drill bit.
3. Lubricate the tool thread with water resistant grease.
4. Use the wrenches to attach the new drill bit.
Maintenance
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
WARNING: To prevent injury, disconnect the
power cord before you do maintenance.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = Speak to a Husqvarna service agent.
Maintenance
Before
each use
After
each use
Daily
After the
first 100 h
After
each 300
h
Make sure that movable parts function correctly and
move freely.
*
Make sure the cutting tool is sharp and clean. *
14 1188 - 005 - 08.01.2020