Husqvarna DE 110i, Руководство оператора, Страница: 21 / 104

CAUTION:
Do not let it dry in full
sunlight. The seals will dry out.
Note:
To clean the with water will gradually decrease
the efficiency of the filter.
1. Loosen the cover locks (A) and open the prefilter
cover (B). (Fig. 42)
2. Remove the prefilter. (Fig. 43)
3. Clean the prefilter with running water from the inner
surface of the prefilter. (Fig. 44)
CAUTION:
The water pressure
must not be higher than 4 bars.
CAUTION:
Do not hit or drag items
across the filter surface as this will do
damage to the filter.
4. Let the prefilter dry fully.
CAUTION:
The prefilter must be
100% dry before you install it into the
housing.
5. Install the prefilter, close the prefilter cover and
tighten the cover locks.
If the prefilter cannot be fully cleaned or if it is damaged,
it must be replaced. Refer to To replace the prefilter on
page 21 .
Filter replacement
WARNING:
Use personal protective
equipment. Refer to
Personal protective
equipment on page 14 . Dangerous dust can
release into the air during filter replacement.
WARNING:
Stop the product and
disconnect the power supply before filter
replacement.
To replace the prefilter
1. Remove the prefilter. Refer to
To clean the prefilter
with water on page 20
.
2. Put the prefilter carefully in a plastic bag.
3. Discard the plastic bag correctly. Refer to local
regulations.
4. Install the new prefilter.
If the suction is not sufficient when a new prefilter is
installed, it is necessary to replace the HEPA filter. Refer
to
To replace the HEPA filter on page 21
.
To replace the HEPA filter
The HEPA filter cannot be cleaned. It is always
necessary to replace it with a new HEPA filter. Only use
HusqvarnaHEPA filters.
WARNING:
Only an approved service
center or an approved authority is permitted
to replace the HEPA filter.
WARNING:
Always use personal
protective equipment, refer to Personal
protective equipment on page 14
.
WARNING:
The particles in the HEPA
filter are dangerous to your health.
WARNING:
Make sure that there are
no holes in the HEPA filter. A damaged
HEPA filter is a health risk.
WARNING:
Do not install a used HEPA
filter. If you install a used HEPA filter,
leakage and decreased filtration efficiency
can occur.
CAUTION:
Do not touch the inner
surface of the HEPA filter. This can cause
damage to the HEPA filter.
1. Loosen the 6 screws and remove the HEPA filter
cover. (Fig. 45)
2. Attach the dust cap (A) and pull out the HEPA filter.
Put it into a clean plastic bag (C). (Fig. 46)
3. Discard the plastic bag correctly. Refer to local
regulations.
4. Install a new HEPA filter. Make sure that the HEPA
filter is pushed to the end position. (Fig. 47)
5. Install the HEPA filter cover and tighten the 6
screws.
1618 - 004 - 24.01.2022 21