Husqvarna AME 1600, Руководство оператора

Страница: 7 / 16

• Use boots with steel toe-cap and non-slip sole.
• Use approved work clothing or equivalent close-
fitting clothing that has long sleeves and long legs.
Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you use the product.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
• Clean the product to remove dangerous material
before you do the maintenance.
• Disconnect the product from the power source
before you do the maintenance.
• Do not do modifications to the product. Modifications
that are not approved by the manufacturer can
cause serious injury or death.
• Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
• Replace damaged, worn or broken parts.
• Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
• After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service agent.
• Let an approved service agent do servicing on the
product regularly.
Operation
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do before you operate the product
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the engine manual that is supplied by the
engine manufacturer.
• Do the daily maintenance. Refer to Maintenance
schedule on page 8
.
To connect the concrete vibrator to the
drive unit
WARNING: Do not connect a concrete
vibrator to a drive unit that is started.
1. Lift the lockpin (A) on the drive unit.
A
B
C
2. Put the connector of the flexible shaft (B) into the
coupling of the drive unit (C). Make sure that the
square connector goes into the square hole in the
coupling of the drive unit.
3. Release the lockpin on the drive unit.
4. Make sure that the lockpin goes back to its initial
position.
To remove the concrete vibrator from
the drive unit
1. Make sure that the power switch is in the OFF
position.
2. Lift the lockpin on the drive unit.
3. Remove the flexible shaft.
1154 - 001 - 05.03.2020 7