Husqvarna 966529101, Руководство оператора и каталог запасных частей

Страница: 9 / 20

9
ASSEMBLY
7
INSTALLING CHUTES
Place middle chute over the top end of the blower 1.
assembly. Stretch the chute latch on the blower
assembly up and onto the acorn nut on the middle
chute.
Slide the upper chute discharge end into the
2.
hood inlet and fit the lower end over middle chute.
Secure as in Step 1.
Acorn Nut
Blower
Latch
6
MOUNTING COVER ASSEMBLY
TO SUPPORT ASSEMBLY
Support
Assembly
For ease of assembly, you may wish assistance from
another person for mounting the cover assembly to
mower.
Position cover assembly on the ground behind the 1.
mower.
Lift and rotate cover to align the frame bracket
2.
with the support assembly and slide the cover
down until secure.
Remove plastic end cap from the center bag
support arm. Fully insert spacer plugs into the
ends of the support tube. It may be necessary
to tap the spacer into place with a hammer or
mallet. Replace the plastic end cap back over
the spacer. The additional extension will hold
the hood more securely when latched.
Remove center
end cap
8
INSTALLING SPACER PLUG
9
CONTAINER INSTALLATION
Install containers on support frame, overlapping 1.
containers at center tube.
NOTE:
One container should always overlap the
other container at the center tube.
Close cover and lock latch handle over support
2.
tubes.
Support
Frame
Latch
Handle
8063-076
Cover
Assembly
Frame
Bracket
Insert spacer and
replace cap