Husqvarna 578BTF, Руководство оператора

Страница: 15 / 76

6. Apply oil to the air filter. Refer to
To apply oil to the
foam air filter on page 15 .
7. Put the air filter in the filter frame.
8. Attach the air filter cover to the product.
To apply oil to the foam air filter
CAUTION:
Always use Husqvarna
special air filter oil. Do not use other types
of oil.
WARNING:
Put on protective gloves.
The air filter oil can cause skin irritation.
1. Put the foam air filter in a plastic bag.
2. Put the oil in the plastic bag.
3. Rub the plastic bag to supply the oil equally across
the foam air filter.
4. Push the unwanted oil out of the foam air filter while
in the plastic bag.
To replace the harness
WARNING:
A damaged harness can
make the product fall and cause injuries.
1. Stop the engine.
2. Remove the clamp from the strap.
3. Push the end of the strap through the hanger.
4. Pull the new strap through the hanger.
5. Attach the clamp to the new strap.
Troubleshooting
The engine is not possible to start
Check Possible cause Solution
Stop button. Stop position Set the stop switch to the start position.
Starter pawl/s. Blocked or
worn starter
pawl/s.
Adjust or replace the starter pawl/s.
Clean around the starter pawl/s.
Speak to an approved servicing dealer.
Fuel tank. Incorrect fuel
type.
Drain the fuel tank and use correct fuel.
Carburetor. Adjustment of
the idle speed.
Adjust the idle speed with the idle adjustment screw.
1913 - 001 - 16.08.2022 15