Husqvarna 530iPX, Руководство оператора

Страница: 11 / 76

To assemble the loop handle
1. Attach the loop handle onto the shaft between the
arrows.
2. Move the spacer into the slot of the loop handle.
3. Install the nut, the knob and the screw. Do not
tighten too much.
4. Adjust the product to an applicable position.
5. Tighten the bolt.
To assemble the guide bar and saw
chain
1. Remove the bar nut that holds the clutch cover.
2. Adjust the guide bar on the guide bar bolt. Put the
guide bar in the rear position. Put the saw chain on
the drive sprocket and in the groove on the guide
bar. Start on the top side of the guide bar.
3. Make sure that the edges of the cutters point forward
on the top edge of the guide bar (C).
4. Align the hole in the guide bar with the chain adjuster
pin and install the clutch cover. Make sure that the
drive links fit correctly on the chain drive sprocket
(B). Make sure that the saw chain is in the groove in
the guide bar. Tighten the bar nuts by hand as tightly
as you can.
C
A
B
5. Apply tension to the saw chain, refer to
To tension
the chain on page 20 .
To adjust the angle of the saw head
WARNING: Stop the product and remove
the battery before you continue. Use
protective gloves.
1. Loosen the screws on the saw head (A).
2. Turn the saw head (B) 90°.
3. Tighten the screws (A).
A
B
To assemble the branch hook
• Use 2 screws to attach the branch hook.
To assemble the shock guard
1. Use 6 screws to attach the shock guard.
To adjust the harness
1. Put on the harness.
2. Attach the harness to the harness support hook.
774 - 001 - 12.11.2018 11