Husqvarna 520iHD60, Руководство оператора

Страница: 12 / 52

3. Make sure that the motor does not touch the hedge.
4. Hold the product near your body for a stable work
position.
5. Make sure that the tip of the cutting equipment does
not touch the ground.
6. Be careful and work slowly until all the branches are
correctly cut.
To start the SavE function
The product has a battery saving function, SavE.
1. Push the SavE button to start the function. A green
LED comes on to show that the function is on.
Automatic shutdown function
The product has a shutdown function that stops the
product if it is not used. The green LED light for start/
stop indication will go out and the product shuts down
after 45 seconds.
To adjust the angle of the product
To get the best operation position, this product can be
adjusted in 5 different positions. If the angle is adjusted,
make sure that the bottom of the rear handle points
down when you operate the product.
1. Release the handle lock and turn the handle.
WARNING: Do not operate the cutting
attachment when you adjust the handle.
To stop the product
1. Release the power trigger or the power trigger
lockout.
2. Push the start/stop button until the green LED goes
out.
3. Push the release buttons on the battery and pull the
battery out.
Maintenance
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance work on
the product.
WARNING: Remove the battery before you
do maintenance on the product.
12 773 - 001 - 22.10.2018