English – 39
TECHNICAL DATA
Recommended cutting equipment for Canada
The following is a list of recommended cutting equipment for chain saw models Husqvarna 365 X-torq, 372XP X-torq
and 327XPG X-torq. The combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-
03 Chainsaws and Z62.3-04 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or ”Type C Low-Kickback Saw Chains” which
are available at your dealer.
Note: For the chains above you are free to choose between 0,050” and 0,058” gauge drive link for the corresponding
bar, see table below.
Saw chain filing and file gauges
Bar
Chain
Length, inch
Pitch, inch
Gauge, inch
Max. nose radius
Type
Drive link count
16
3/8
0,058
11T
Husqvarna H42,
Husqvarna H48
60
18
3/8
0,058
11T
68
20
3/8
0,058
11T
72
24
3/8
0,058
11T
84
28
3/8
0,058
11T
93
0,050"/1,3 mm
H46
H47
0,058"/1,5 mm
H42
H48
!
WARNING! This chain saw model is capable of severe kickback that could result in serious
injuries to the user. Do not operate this saw unless you have extraordinary cutting needs and
experience and specialized training for dealing with kickback. Saw chains with significantly
reduced kickback potential are available. Always use the safest saw and cutting equipment
applicable to your cutting need.
