![Husqvarna 360BT Скачать руководство пользователя страница 69](http://html.mh-extra.com/html/husqvarna/360bt/360bt_operators-manual_170525069.webp)
1. Stop the engine.
2. Remove the clamp from the strap.
3. Push the end of the strap through the eyelet.
4. Pull the new strap through the eyelet.
5. Put the pin into the strap to attach the clamp to
the new strap.
Troubleshooting
The engine is not possible to start
Check
Possible
cause
Solution
Stop button.
Stop position
Set the stop switch to the start position.
Starter pawl/s. Blocked or
worn starter
pawl/s.
Adjust or replace the starter pawl/s.
Clean around the starter pawl/s.
Speak to an approved servicing dealer.
Fuel tank.
Incorrect fuel
type.
Drain the fuel tank and use correct fuel.
Carburetor.
Adjustment of
the idle speed.
Adjust the idle speed with the idle adjustment screw.
Spark (no
spark).
Spark plug
dirty or wet.
Make sure that the spark plug is dry and clean.
Electrode gap
on the spark
plug is incor-
rect.
Clean the spark plug. Make sure that the electrode gap is correct. Make
sure that the spark plug is installed with a suppressor.
Refer to technical data for the correct electrode gap.
Spark plug.
Spark plug is
loose.
Tighten the spark plug.
There is un-
wanted mate-
rial on the
spark plug
electrodes.
Make sure that the fuel mixture is correct.
Make sure that the air filter is clean.
Engine starts but stops again
Check
Possible
cause
Solution
Fuel tank.
Incorrect fuel
type.
Drain it and use the correct fuel.
1750 - 003 - 03.03.2022
69