Husqvarna 327ES, Руководство оператора

Страница: 11 / 28

ASSEMBLY
English
–
11
Fitting the loop handle
• Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.
• Fit the bolt, securing plate and wing nut as shown in
the diagram.
• Tighten the wing nut.
Assembling the angle gear
• Assemble the angle gear back on the suppporting
tube. Turn the blade so that the drive shaft engages in
the angle gear.
• Tighten the two screws.
Assembling the cutting
equipment
Assembling the blade
Fit the blade as follows:
1 Fit the drive disc (A) on the outgoing shaft. Make sure
that the edge that fits in the hole of the blade is facing
outward.
2 Block the blade rotation by inserting the locking pin in
the hole behind the blade guard engaging it in the
corresponding hole in the drive disc.
3 Fit the blade (B) on the drive disc.
4 Fit the support flange (C). The support flange must be
fitted with its outer edge hard up against the blade.
5 Fit the two washers (D) and the locking screw (E).
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
!
WARNING! Under no circumstances may
the edge cutter blade be used without the
blade guard fitted.
A
B
C
D
E