Husqvarna 326SX Series, Руководство оператора

Страница: 9 / 24

9 –
English
ASSEMBLY
Assembling the sweeper
• Slide the plastic sleeve (wear protection) (A) onto the shaft
(B).
• Fit the gearbox (C) on the tube (B). Tighten clamp screw (D)
at the gearbox. Tighten the two locking screws (E) on the
gearbox.
• Press one of the roller shafts (F) onto one of the two output
drive shafts from the gearbox. If necessary rotate the roller
shaft so that the hole for the pin lines up with the
corresponding hole in the drive shaft.
• Secure the roller shaft on the drive shaft using a pin (G) and
hairpin spring (H).
• Slide one of the sweeper rollers (I) onto the fi tted tube. The
end with the extended rubber blades must be fi tted closest
to the gearbox. Slide the sweeper roller on until it touches
the pin.
• Secure the roller to the shaft using a split pin (K) (see
diagram). The split pin must be
fl ush with the outer end of the
roller, so you may need to push on the end plate slightly to
fi t it.
• Repeat steps 1-7 to fi t the shaft and roller on the other side.
Fitting the loop handle
• Position the handle on the shaft. Note that the handle must
be mounted below the arrow on the shaft.
• Fit the screw, securing plate and wing nut as shown in the
diagram.
• Tighten the wing nut.
CAUTION! The rollers are identical, but they must both be
fi tted with the extended rubber blades nearest the gearbox.