Husqvarna 125 TC EU, Руководство пользователя

Страница: 35 / 109

11 SERVICE WORK ON THE CHASSIS
33
11.1 Raising the motorcycle with the lift stand
401942-01
–
Raise the motorcycle at the frame below the engine.
The wheels should no longer touch the ground.
–
Secure the motorcycle against falling over.
Lift stand (54829055000)
11.2 Removing the motorcycle from the lift stand
Note
Danger of damage
The parked vehicle may roll away or fall over.
–
Always place the vehicle on a firm and even surface.
0 0 1
1
402001-10
–
Remove the motorcycle from the lift stand.
–
Remove the lift stand.
–
To park the motorcycle, insert plug-in stand 1 into the left side of the wheel spin-
dle.
Info
Remove the plug-in stand before riding.
11.3 Bleeding the fork legs
Preparatory work
–
Raise the motorcycle with the lift stand. ( p. 33)
L01910-10
Main work
–
Release bleeder screws 1 .
Any excess pressure escapes from the interior of the fork.
–
Tighten the bleeder screws.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 33)
11.4 Cleaning the dust boots of the fork legs
Preparatory work
–
Raise the motorcycle with the lift stand. ( p. 33)
–
Loosen the fork protection. ( p. 34)
B00297-10
Main work
–
Push dust boots
1
of both fork legs downwards.
Info
The dust boots remove dust and coarse dirt particles from the inside fork
tubes. Over time, dirt can penetrate behind the dust boots. If this dirt is not
removed, the oil seals behind can start to leak.