Husqvarna 120e MARK II, Руководство оператора

Страница: 20 / 40

5. Make one or more cuts of sufficient depth necessary
to decrease the tension. Cut at or near the point of
maximum tension. Make the tree or branch break at
the point of maximum tension.
WARNING: Do not cut straight through a
tree or branch that is in tension.
WARNING: Be very careful when you
cut a tree that is in tension. There is a
risk that the tree moves quickly before or
after you cut it. Serious injury can occur
if you are in an incorrect position or if
you cut incorrectly.
6. If you must cut across tree/branch, make 2 to 3 cuts,
1 in. apart and with a depth of 2 in.
7. Continue to cut more into the tree until the tree/
branch bends and the tension is released.
8. Cut the tree/branch from the opposite side of the
bend, after the tension is released.
To use the product in cold weather
CAUTION: Snow and cold weather can
cause operation problems. Risk of too low
engine temperature or ice on the air filter
and the carburetor.
1. Clothe a part of the air intake on the starter. This
increases the engine temperature.
2. For temperatures below -5°C/23°F or in conditions
with snow, a winter cover is available. Assemble the
winter cover on the starter housing. The winter cover
decreases the flow of cool air and keeps snow away
from the carburetor space.
Note: Part number for winter cover: 595 96 76-01
CAUTION: Remove the winter cover if
the temperature increases above -5°C/
23°F. Risk of too high engine
temperature and damage to the engine.
Heated handles (545G Mark II, 550XPG Mark
II)
The product has heated front and rear handles. The
electrical heating coils are powered by a generator.
Push the switch in the direction of the arrow to engage
the function. Push the switch in the opposite direction to
disengage the function.
Electrical carburetor heating (545G Mark II,
550XPG Mark II)
Adjustment of the carburetor heating is done electrically
through a thermostat. This keeps the correct carburetor
temperature and prevents ice in the carburetor.
20 544 - 005 - 10.05.2019