Husky Trim-Plus H1503TP-R, Руководство оператора

Страница: 14 / 36

14
Fig. 7B
Fig. 7A
THREAD
SEALING
TAPE
THREAD
SEALING
TAPE
See Figures 7A - 7B
Ensure tank drain is closed.
Turn regulator knob counter clockwise until outlet
pressure is at zero (0).
Ensure power switch is in the OFF ( 0 ) position and air
compressor is unplugged.
If not ready installed, attach hose to compressor as
previously instructed.
Attach 1/4 in. NPT male connector fitting to accessory
or tool you intend to use.
Insert the other and of the male connector to the quick
coupler on the open end of hose
Operating air powered tools requiring up to 2.5 SCFM.
Inflating tires, air beds, sports equipment, etc.
Turn the switch ON (I) and allow tank pressure to build.
NOTE:
Always use the minimum amount of pressure
necessary for your application. Using a higher pressure
than needed could cause serious injury and may
permanently damage the tool.
Always ensure the swith is in the OFF (O) position and
the regulator pressure gauge reads zero before chang-
ing air tools or disconnecting the hose from the air
outlet. Failure to do so could result in possible serious
personal injury.
Connect the power cord to the power supply.
Rotate pressure regulator knob to desired line pres-
sure. Turning the knob clockwise increases air pres-
sure at the outlet; turning countercolockwise reduces air
pressure at the outlet.
Following all safety precautions in this manual and the
manufacturer’s instructions in the air tool manual, you
may now proceed to use your air-powered tool.
Check the air tool manual to insure the correct air
pressure regulator setting for optimum operation of
your air tools. If you arre using an air tool not originally
included with the air tool kit supplied with this air
compressor, your tool may require more air consumption
than this air compressor is designed to supply.
Always read your air tool owners manual to match the
correct air supply to your air tool to avoid damage
to the tool or risk of personal injury.
If using an inflation accessory, control the amount of air
flow with the pressure regulator knob. Turning the knob
fully counterclockwise will completely stop the flow of
air.
When finished, always drain the tank and unplug the
unit. Never leave the unit plugged in and/or running
unattended.