47952.doc
09/11/2006
reposition them before completing handle installation. Repositioning a spacer that has fallen out is easily done
by resting the spacer on your finger and raising the spacer up into the handle opening from the inside of the
drawer. To avoid the spacer falling out do not tip drawer when handle bolts are removed.
7) Remove the 3/8”-24 lock nut, cam latch and spacer from Handle Assembly. Align handle with holes (shank
will pass through opening in drawer) and re-install the 10-32 flathead bolts/nuts using 1/8” Allen Wrench. On
the inside of the drawer, re-install the spacer, cam latch and 3/8”-24 lock nut on handle shank, tighten nut only
finger tight. Turn handle and note the position of the cam latch. The cam latch should be oriented on handle
shank so that it will secure drawer unit when handle is horizontal on drawer (see note #2).
8). Remove 3
rd
row seat(s) from vehicle and fold second row seats forward.
The next steps are vehicle specific. Please skip down to the remaining instructions for your specific application.
2000-2006 Suburban/Yukon XL/Yukon XL Denali/Cadillac Escalade ESV:
Remove the two rear cargo tie-
down loops from cargo area using a T50 Torx wrench. Position the two short 1” round spacers provided in the
recesses where tie-down loops were removed. The storage box will later be positioned over these stand-offs and
bolted into place.
9) Remove Access Panel from rear of Storage Box using a 1/8” Allen Wrench. Carefully slide drawer case into
cargo area.
10) Insert one (1) of the 3/8” X 3_” Hex Bolts through hole in either end of the channel iron. Screw a Nut Plate
onto each of the 2 bolts a few turns (see note #3).
11) Position the Channel Iron over the front set of the 3
rd
seat mounting rods.
12) Insert the remaining 3/8” X 3_” Hex Bolts through the remaining 2 holes in the channel iron, threading
them into Nut Plates (see note #8). The Nut Plates should be positioned so that they will be pulled against 3
rd
seat mounting rod when bolts are tightened. Do not tighten at this time.
13) Position the two, 4” pieces of strap so that one piece is centered under each end of the Channel Iron (see
note 4).
14) Evenly tighten all bolts; do not over tighten.
15) Guide drawer back into drawer slides and re-insert detent pins.
16) Replace Access Panel.
17) Install Drawer Liner (foam) into drawer.
18) Install Cargo Liner by first centering liner on top of Drawer Unit. Then, insert the Cargo Liner Retention
Block into the recess molded into the cargo liner. Using the Phillips Head Screwdriver, install the three #8 X 1-
1/4” Stainless Steel Wood Screws through the holes in the Retention Block and into the top of the Storage Box
(see note #5). Take care to make sure the liner is center before attaching.
19) Your Storage Box should be treated as you would the exterior of your vehicle. Wash with gentle soap and
water and rinse well. The easiest way to clean the drawer liner or cargo liner is with a damp cloth or sponge. If
using a cleaner, 409® or Glass Plus® work well. The use or Armor All®, Son-of-a-Gun® or similar items is
discouraged as the products make the liner slick.
