ECO-7EZ - OPERATOR MANUAL
8
Copyright
©
Huskie Tools 2019
MODEL: ECO-7EZ
OPERATING INSTRUCTIONS
Compression
1. Select an appropriate size of die for the connector.
2. Insert the dies into the jaw by pressing the push pins. When released, they will hold the die in place.
See Figure 8A.
3. Place the connector between the dies and press the trigger to advance the ram so the connector is
held between the dies and insert the conductor into the terminal.
4. Press and hold trigger until the compression is complete. See Figure 8B. The ram will advance to
close the tool jaws and once the cycle is complete, the tool will continue to run while trigger is de-
pressed.
5. Press the release trigger to open the tool jaw and remove the connector. See Figure 8B.
6. Low battery LED indicator will illuminate orange when battery has 3-5 compression cycles remain-
ing. See Figure 8C.
Figure 8A.
Figure 8B.
ɨ
When the battery pack has deteriorated, replace it with a new one. Continued use of a damaged
battery pack may result in heat generation, ignition or battery rupture.
ɨ
When storing, remove any material cuttings and dust from the battery pack, and place the battery
pack separately from metal objects (screws, nails, etc.) when storing in the tool case.
Figure 8C.
Advance
Trigger
Release
Trigger
Push
Pins
Low
Battery
Indicator
