WORK
7
Info
Even when there is no load on the battery, it is still depleted slightly every day.
The charging level and type of charge are very important to the battery service life.
Rapid charging with a high charging current has a negative impact on the service life.
If the charging current, charging voltage and charging time are exceeded, electrolyte escapes via the safety valves. This
reduces the battery capacity.
If the vehicle is started repeatedly until the battery is depleted, the battery must be charged immediately.
If the battery is left in a discharged state for an extended period, it will drain completely and sulfate, destroying the battery.
The battery is maintenance-free, which means that the acid level does not need to be checked.
–
Switch off all power consumers and the engine.
–
Remove the seat. (
–
Disconnect the negative cable of the battery to avoid damage to the onboard elec-
tronics.
100425-10
–
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (81229074000)
You can also use the battery charger to check the off load voltage, the starting abil-
ity of the battery and the generator. The device also makes it impossible to over-
charge the battery.
Info
Never remove cover
.
Charge the battery with a maximum of 10% of the capacity specified on
battery housing
.
–
Switch off the battery charger after charging.
Guideline
Charging current, charging voltage and charging time may not be exceeded.
Recharge the battery regularly if the
motorcycle is not put into operation
3 months
Tip
If the vehicle is not ridden for more than two weeks, we recommend trickle
charging the battery with the HUSABERG battery charger. The battery is
first charged completely and then maintained at this level over the subse-
quent period. Thus, the battery is always fully charged when the vehicle is
put into operation.
–
Connect the negative cable.
Info
Contact disk
must be mounted between battery terminal
and cable
socket
with the claws facing up.
–
Tighten the screw.
Guideline
Screw, battery terminal
M5
3 Nm (2.2 lbf ft)
–
Mount the seat. (
3.8
Setting kilometers or miles
Info
If you change the unit, the value
ODO
is retained and converted accordingly.
The values
TR1
,
TR2
,
A1
,
A2
and
S1
are cleared when the unit of measure is changed.
Condition
The motorcycle is standing.
