WORK
6
–
Fully tighten screw
.
Guideline
Screw, fork stub
M8
15 Nm
(11.1 lbf ft)
3.4
Installing the engine guard
100450-10
–
Attach the engine guard on the frame at the rear and swing it up and forward.
Mount and tighten screw
.
Guideline
Remaining screws, chassis
M6
10 Nm (7.4 lbf ft)
3.5
Removing the seat
100362-10
–
Pull on the loop
while raising the rear of the seat.
–
Pull the seat back and lift it off.
3.6
Mounting the seat
400514-10
–
Attach the seat to the hooks on fuel tank
and on the top part of subframe
,
and lower it at the rear while pushing forward.
–
Guide lock bolt
into the lock housing and push down the rear of the seat until
the lock bolt engages audibly.
–
Finally, check that the seat is correctly mounted.
3.7
Charging the battery
Warning
Risk of injury
Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
Warning
Environmental hazard
Components and battery acid are a danger to the environment.
–
Do not dispose of batteries in normal household waste. Take defective or used batteries to a battery recycling operator.
Warning
Environmental hazard
Problem materials cause environmental damage.
–
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc., according to regulations.
