HUROM M100 Series, Инструкция по эксплуатации

Страница: 18 / 21

17 17 12. Before Requesting for Repair
13. Error Code (common for juicer and blender)
Code Root cause Actions to take
Er01
If an overcurrent flows through the product,
this error is generated to protect the
product.
Stop operating the product and restart it
after a few minutes.
If the same problem continues to occur,
please contact the HUROM After-sales
Service Center.
Er04
If a high voltage is applied to the product,
this error is generated to protect the
product.
Stop operating the product and restart it
after a few minutes.
If the same problem continues to occur,
please contact the HUROM After-sales
Service Center.
Er06
1. If the automatic reverse rotation is
operated often during the juicer operation,
this error may be generated to protect the
product. (This is an operation to protect
the chamber in case hard ingredients
or ingredients unable to be juiced are
inserted.)
2. This error may be generated if the motor
fails to perform the initial activation while
there are too many ingredients in the
blender container.
3. This error may be generated if the
overloading on the motor leads to activation
of the temperature protection device.
4. This error may be generated if the sensor
that detects the motor’s operation is broken.
1. Stop operating the product, check and
remove the contents inside the juicer’s
chamber set, and then restart it.
2. Stop operating the product and reduce
the amount of contents inside the blender
container or raise the motor speed at the
initial operation.
3. If the motor stops due to overloading,
let it rest for about 30 minutes before
operating the machine again.
4. If the same problem continues to occur,
please contact the HUROM After-sales
Service Center.
└┘
This error may be generated if the jog dial or
the [START/STOP] button is controlled while
there is no juicer chamber set or blender
container on the product body.
Install the juicer or blender container on
the product body before use.
If the same problem continues to occur,
please contact the HUROM After-sales
Service Center.
Juicing is automatically
terminated before the
5-minute timer ends.
It is a function that automatically shuts down to protect the product in case the
automatic reverse rotation is operated often during juicing. This may occur if it is
impossible to extract or if uncut ingredients are added.
Please refer to Page 12 of the manual for the instructions on each ingredient and
insert the ingredients accordingly.
Blender
The motor stops while the
blender is in operation.
If the blender is overloaded, the motor may stop. Turn off the power and remove
the ingredients that cause the overloading or let it rest for about 30 minutes.
Blender’s grinding
operation does not work.
The machine may stop operating if there are too many ingredients or the
ingredients are too thick.
Adjust the amount and size of the ingredients and then operate the machine again.
In case dry ingredients are used in a large volume, add more liquid before
operation.