EN
6
BASIC DATA
Name
Single bowl chip fryer
Double bowl chip fryer
Model
HKN-FT10N
HKN-FT1010N
Voltage
220
～
240 V
220
～
240 V
Power
4.0 kW
8.0 kW
ELECTRICAL DIAGRAM
S
—
Temperature adjuster.
EH
—
Tubular electrical heater
HL1
—
Power indicator (GN)
E
—
Grounding
HL2
—
Heating indicator(YE)
INSTRUCTIONS
1. Before installation, make sure that the mains' voltage corresponds to the specified parame-
ters and is safe.
2. During operation, the oil level should be above the middle of the tank.
3. 1) Press the electric power switch K1, the red indicator shall light up while the power is sup-
plied. Turn the temperature adjustment knob clockwise and set the red arrow to the desired
degree value. At the same time, the amber indicator shall turn on and the red indicator shall
turn off, which means the tubular electric heater starts heating. The oil temperature shall start
rising.
2) When the temperature reaches the desired value, the thermostat shall automatically turn
off, the amber indicator shall turn off as well, and the red indicator shall turn on, the tubular
electric heater shall stop heating.
3) When the temperature decreases a little, the thermostat shall automatically turn on the
power, the amber indicator shall turn on and the red indicator shall turn off, the tubular electric
heater shall resume heating, the temperature shall rise.
4) The operation shall be carried out in a cyclic mode to maintain the temperature within the
set range.
4. The cover is necessary to keep it clean and warm. When installing the cover, be careful to
avoid water in the tank as this may cause oil splashes.
