17
8. Electromagnetic
Compatibility
Make sure the environment in which the equipment is installed is not subject to strong
sources of electromagnetic interference (e.g. radio transmitters, mobile phones).
This equipment generates and uses radio frequency energy. If not installed and used
properly, in strict accordance with the manufacturer’s instructions, it may cause or be
subject to interference. Type-tested in a fully con
fi
gured system, complies with EN60601-
1-2, the standard intended to provide reasonable protection against such interference.
Whether the equipment causes interference may be determined by turning the equipment
off and on. If it does cause or is affected by interference, one or more of the following
measures may correct the interference:
•
Reorienting the equipment
•
Relocating the equipment with respect to the source of interference
•
Moving the equipment away from the device with which it is interfering
•
Plugging the equipment into a different outlet so that the devices are
on different branch circuits
WARNING: The use of accessories, transducers and cables other than
those speci
fi
ed, with the exception of transducers and cables sold by the
manufacturer of the Smartsigns® Compact 300 as replacement parts for
internal components, may result in increased emissions or decreased
immunity of the Smartsigns® Compact 300.
WARNING: The Smartsigns® Compact 300 should not be used adjacent
to or stacked with other equipment and that if adjacent or stacked use is
necessary, the Smartsigns® Compact 300 should be observed to verify
normal operation in the con
fi
guration in which it will be used
WARNING: Portable RF communications equipment (including peripherals
such as antenna cables and external antennas) should be used no closer
than 30 cm (12 inches) to any part of the Smartsigns® Compact 300
including cables speci
fi
ed by the manufacturer. Otherwise, degradation of
the performance of this equipment could result.
Guidance and Manufacturer’s declaration - electromagnetic emissions
The IRT10 infrared ear thermometer is intended for use in the electromagnetic environment
speci
fi
ed below. The customer or the user of the IRT10 infrared ear thermometer should assure that
it is used in such an environment.
Emissions Test
Compliance
Electromagnetic Environment - guidance
RF emissions
CISPR 11
Group 1
The IRT10 infrared ear thermometer uses RF energy only
for its internal function. Therefore, its RF emissions are
very low and are not likely to cause any interference in
nearby electronic equipment.
RF emissions
CISPR 11
Class A
The IRT10 infrared ear thermometer is suitable for use in
all establishments, other than domestic and those directly
connected to the public low-voltage power supply network
that supplies buildings used for domestic purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage
fl
uctuations /
fl
icker emissions
IEC 61000-3-3
Complies
Setting up the Monitor
Содержание IRT10
Страница 1: ...Wireless Tympanic Thermometer IRT10...
