Front Side
Of Shading
1
2
4
5
3
Hunter
Douglas
®
Hunter
Douglas
®
Hunter
Douglas
®
Hunter
Douglas
®
Hunter
Douglas
®
Headrail
Flange
Locking Tab
Installation
Bracket
Headrail
Installation
Bracket
Push Until
Locking Tab
Secures
Headrail
Lift Locking Tab To
Release Headrail
Insert Card
Between
Headrail And
Locking Tab
Extension
Bracket
1
1
/
2
"
Minimum
Depth
Adjust The Shading
Test The Shading
Lower the shading, then slowly raise it.
If the fabric rolls unevenly or rubs against the end cap,
check that the headrail is level. Level, if necessary.
If the headrail is level, adjust the bottom rail weight.
•
•
•
2
3
Weight
Weight
Clip
Weight
Clip
4
End Mount Applications
End mount the headrail when
conventional mounting techniques
will not work, for example, in an
arched window.
Mount the extension brackets on a
surface at least 1
1
/
2
" wide.
Attach the installation brackets to the
extension brackets using the machine
screws and nuts provided.
Install The Shading
Remove the protective
covering from the fabric-
covered headrail.
Hold the shading so the
front faces you.
Push the top edge of the
headrail
under the locking tab
on the installation bracket until
it snaps into place. The locking tab will be visible.
WARNING:
Failure to snap the headrail securely into the
installation bracket and engage the locking tab may cause the
shading to release unexpectedly.
Operate The Shading
Pull on the rear cord of the cord loop to lower the shading.
With the shading fully lowered, continue to pull on the rear
cord to tilt the bottom rail and open the vanes.
Pull on the front cord of the cord loop to close the vanes and
raise the shading.
•
•
•
•
•
•
•
•
Adjust The Bottom Rail Weight
To release, insert a flat blade screwdriver
into a weight clip and turn clockwise.
Move the weight in 1" increments toward
the side where the fabric is gathering.
Secure the weight clips in position by turning them
counterclockwise after making the adjustment.
Test and, if necessary, adjust again.
NOTE:
Skew adjustment is not possible by moving the limit
stop assemblies.
Attach The Accessories
Install The Cord Tensioner
See the Universal Cord Tensioner Installation Instructions.
Attach The Dust Cover (Optional)
Use the entire cover on outside mounts.
On inside mounts, trim the cover along a score to fit over the
portion of the headrail that protrudes from the window frame.
Cut the cover to fit between extension brackets, when used.
Peel the backing from the double-sided tape to attach the
cover to the headrail.
Attach The Hold-Down Brackets (Optional)
Hold-down brackets secure the bottom
rail to the sill when the window shading is
fully lowered. The bottom rail can still pivot
when opening and closing the vanes, but the
shading cannot be raised.
With the shading fully lowered, insert the pin on the
hold-down bracket into the hole on the bottom rail end cap.
Mark the mounting hole locations on the mounting surface.
Center the hold-down brackets over the mounting hole
locations and check their alignment. Attach using two screws.
NOTE:
Disconnect the bottom rail from the hold-down brackets
to raise the shading.
•
•
•
•
•
•
•
•
•
•
•
5
Fabric Roll
Bottom Rail
Move Weight
Hole
Back Of
Shading
Overhead View – No Dust Cover
Dust Cover (Outside Mount)
Dust Cover (Inside Mount)
Cut Along A Score To Size The Dust Cover
To Fit Any Exposed Part Of The Headrail Assembly
