In addition, you will need fasteners designed to work with your
specific mounting surfaces:
Contents of the hardware package may vary depending upon
how the shading was ordered and whether the shading will be
inside or outside mounted.
Mount The Installation Brackets
Bracket Placement
Measure 2" in from the ends of the headrail and mark the
bracket location on the mounting surface.
Bracket placement is the same for inside and outside mounts.
Inside Mount Applications
Back Cover Bracket
Installation (Optional)
If using the back cover brackets, use
pliers to break off both tabs
on the installation brackets.
Snap the prongs on
the back cover brackets into
the holes on the back of the
installation brackets.
CAUTION:
Do not push down
on the limit stops. Limit stop
angle is set at the factory.
Over-adjusting the limit stop
is not reversible and may
damage the shading.
•
•
•
•
3
/
4
"
Minimum
2"
Mark
On Wall
Back
Cover
Back Cover
Bracket
Installation
Bracket
12" - 36"
36
1
/
8
" - 79"
79
1
/
8
" - 96"
96
1
/
8
" - 120"
Brackets Required
Shade Width
2
3
4
5
Mounting Surface
Fastener
No. 6 Hex Head Screws
(Provided)
Wall Anchors, Expansion Bolts
(Not Provided)
Wood, Metal
Drywall, Plaster
Sheet Metal Screws
(Not Provided)
1
2"
2"
Limit Stops (5
1
/
2
" From Ends)
Space Evenly
Space Evenly
Normal Spacing (Shadings Over 36" Wide):
5"
5"
Limit Stops (2" From Ends)
Space Evenly
Obstruction Spacing (Maximum):
Space Evenly
Spacer
Block
1
/
2
"
1
/
2
"
Removable
Tabs
Installation
Bracket
Remove This Tab
Back
Cover
Bracket
2"
Minimum Depth
Required =
7
/
8
"
Fully Recessed
Depth = 3
1
/
4
"
Bracket Installation
Use pliers to break off the upper tab of each bracket.
NOTE:
Remove the bottom tab on each installation bracket only
if it interferes with the bracket installation.
Center each bracket
over a mark on the
mounting surface.
Adjust bracket placement
to accommodate any
obstructions to the bottom
rail, such as window cranks
or handles.
Check that each bracket is level
and the front edges are aligned.
Attach using two screws.
Back Cover Installation (Optional)
After bracket installation,
install the cover into the
back bracket, as shown.
Outside Mount Applications
The outside mount minimum height is
3
/
4
".
Bracket Installation
Center the shading over the window and mark
the ends of the headrail.
Measure 2" in from the marks on the wall
and mark the bracket locations.
Use pliers to break off
both tabs on each
mounting bracket.
Center each bracket over
the marks on the
mounting surface.
Adjust bracket position
to accommodate any
obstructions to the bottom
rail, such as window cranks
or handles.
Check that each bracket is level
and the tops are aligned. Attach
using two screws.
Spacer Blocks (Optional)
Each spacer block projects brackets
1
/
2
"
from the mounting surface.
Mount spacer blocks with
the solid side facing the
mounting surface.
Use two mounting screws.
Screws should be long
enough to secure the
bracket to the
mounting surface.
Use a maximum of three
spacer blocks per bracket.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
