INSTALLATION
4
Valance Assembly
Please refer to the section below for your valance type.
Crestover
™
Wood Valance (Using Dovetail Corner Clips) Assembly
■
Slide the two dovetail clips attached to the
wood valance face into the corresponding
grooves on the valance returns.
NOTE:
If the returns are too long, they can
be shortened using a cut-off saw to remove
material from the back edge. Do not cut the
miter corners to shorten the returns.
Proceed to “Mount the Installation Brackets — Inside Mount” on page 7 or “Mount the
Installation Brackets — Outside Mount” on page 9 based on the mounting option ordered.
Dust Cover Valance Assembly
Single-Tiered Closed Corner
■
Cut a fabric insert for the valance and each valance return 1" longer at each end than the
valance and valance return width.
■
Center the fabric insert in the valance and wrap the excess on each side around to the back
of the valance.
■
At one end, hold the fabric insert in place with a
corner clip.
■
At the opposite end, pull the fabric insert tight and
secure it in place with another corner clip.
■
Center each valance return fabric insert and wrap
the excess on each side around to the back of the
valance return.
■
Attach the valance return to the valance using the
already attached corner clip.
■
At the opposite end of the valance return, pull the
fabric insert tight and secure it in place with a
valance return clip.
Dovetail Clips
Dust Cover
Valance
Return
Wood
Face
Corner
Clip
Valance
Return
Valance
Valance Return
Clip
Fabric
Insert
