TROUBLESHOOTING
30
Problem
The LED light behind the control button of the transceiver
assembly signals 8 red blinks.
Solution
This is the low battery indicator. Replace the batteries in the battery wand or
rechargeable battery wand.
Problem
SimpleLift
™
with PowerView
®
Gen 3 blinds only:
When raising the blind,
slats are not stacking evenly and falling over the bottom rail.
Solution
The blind was raised too quickly. Gently raise the bottom rail to give the lift
cords time to retract. The slats will then stack evenly on the bottom rail.
Problem
SimpleLift with PowerView Gen 3 blinds only:
The bottom rail is not level
or the blind height is incorrect.
Solution
Check that the headrail and installation brackets are level and aligned. Adjust
and/or shim the installation brackets to level, if necessary.
Level the Bottom Rail or Correct Blind Height:
NOTE:
All skew adjustment features are located under the headrail.
■
To level the blind, raise the low side of the
bottom rail by turning the skew adjustment
feature on the headrail clockwise with a
coin or screwdriver, while lifting the weight
from the bottom rail.
NOTE:
Turn the skew adjustment that
is on the same side as the low side of
the bottom rail.
■
If the blind height is too long, turn all of the
skew adjustment features clockwise to raise the entire bottom rail to the
desired height while lifting the weight from the bottom rail.
Problem
SimpleLift with PowerView Gen 3 blinds only:
The blind makes a
ratcheting noise while the center button is pushed in and the bottom rail is
being raised.
Solution
Push harder on the center button. The button must be fully depressed to raise
or lower the blind.
Содержание EverWood
Страница 34: ...CHILD SAFETY 32 ...
