Hunter MAVERICK MV500, Руководство пользователя

Страница: 20 / 42

Spark plug inspection
1. Open the spark plug cap and use a spark plug wrench to unscrew the spark plug.
2. Clean the spark plug. If the spark plug is corroded or there is too much deposit, replace the spark plug.
3. The spark plug gap is adjusted to 0.8mm-0.9mm.
4. Please use the specified spark plug CPR8EA-9 (NGK).
1. Spark plugs must not be over tightened or cross-threaded to avoid damaging the threads of the cylinder. When
removing the spark plug, do not allow impurities to enter the engine through the spark plug hole.
2. The spark plugs for this type of motorcycle are carefully selected to suit most of the working range. If the color of the
spark plug is not the same as the standard spark plug, it is best to consult with your Hunter dealer before replacing the
spark plug with different heat resistance range, because the selection of the improper spark plug will cause serious
damage to the engine and can cause your Warranty to be null and void.
Air cleaner inspection
For the special air filter, the exhaust nozzle is installed to improve the air flow and filtration efficiency. The exhaust nozzle
is connected to the engine crankcase, so that the crankcase exhaust gas enters the combustion chamber through the filter
and burns again without being directly discharged into the atmosphere. Remove the air filter to check for
contamination.(Disassembly) Remove the end cover of the air filter, and pull out the screw to disassemble the air filter.
Replace with a new air filter and reassemble.
Note: The filter element of the assembled air filter should be in good condition, otherwise the engine will absorb dust and
dirt and shorten the service life of the engine. Avoid water in the air filter when washing the motorcycle. Do not use
gasoline or a low-burning cleaning agent to clean the filter element.
20
Warning / Attention