www.HunterFan.com
1.888.830.1326
Operation, Maintenance, & Cleaning
The remote transmitter is
already
paired to the
receiver and ready to use.
Note:
If your need to pair your remote, turn fan
power off and back on at the wall switch. Within 3
minutes, press and hold both the Fan Off button
and the High button for 4 seconds to pair the
remote.
To prevent faulty operation, please
ensure all other ceiling fans within range are
turned off at the wall switch while pairing.
To access the battery compartment, remove the
small Phillips head screw that secures the battery
door to the transmitter assembly. Install one
3-Volt, CR2032 battery, found in the remote control
hardware bag, into the transmitter. Clean the battery
contacts and also those of the device prior to battery
installation. The battery should be installed with the
positive (+) side up. Please contact your local battery
recycling center for proper battery disposal information.
ON
Turn P
ow
er
This product contains a button battery. If swallowed,
it could cause severe injury or death in just two hours.
Seek medical attention immediately.
CAUTION:
• Always purchase the correct
size and grade of battery most
suitable for the intended use.
• Replace all batteries of a set at
the same time.
• Clean the battery contacts and
also those of the device prior to
battery installation.
• Ensure the batteries are
installed correctly with regard to
polarity (+ and -).
• Remove batteries from equipment
which is not to be used for an
extended period of time.
• Remove used batteries promptly.
Phillips
Head
Screw
Battery
Door
REMOTE PAIRING
17
M3571-01 • 06/29/16 • © 2016 Hunter Fan Company