8
1886
1886
Blade Arm Screw
Installing the Light Fixture
Ceiling Bracket
Downrod
Hanging Fan
Wiring
Canopy
Blades
Light
Bulbs/Cage
Remote Cradle
Installing the Bulbs and Cage
ON
Turn P
ow
er
Install the included LED
bulbs into the sockets.
When necessary, replace
with bulbs of same wattage.
Lift the cage and align the
notches in the globe with
the tabs in the light kit.
NOTE: Check to ensure
proper engagement.
Attach the cage by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Notch
Tab
WARNING
GLASS FALL HAZARD
To prevent
SERIOUS INJURY
or
DEATH
, make
sure that glass is properly secured.
Insert the third screw,
found in the
hardware
bag, into place and then
tighten all three screws.
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Feed the wire plug through the
center hole of the upper switch
housing, then wrap keyhole
slots around the screws and
twist counterclockwise.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
2 of 6
Light Kit Screw
bag
1 of 6
Light Kit Screw
bag
Partially install two of
the switch housing
assembly screws found
in the
bag. It does
not matter which two
screw holes you choose.
Align the keyhole slots in the light kit
housing with the two screws. Turn the
light kit counterclockwise until the light kit
screws are firmly situated in the narrow
end of the keyhole slots. Install the third
screw and tighten all three screws securely.
1 of 6
Light Kit Screw
bag
2 of 6
Light Kit Screw
bag
Connect the plugs from the
upper and lower switch
housings. Make sure to line
up the colored markings on
the connectors
Carefully lower the glass
into the light fixture cage
until it rests in place.
Fan style may vary.
Note:
Fan style may vary.
Note:
