NOTE: Grommets are usually assembled by hand. If you use a
tool, make certain you do not damage the grommet or blade
when inserting the grommets.
Next assemble the blade to the blade bracket. Make sure all
screws are tight to prevent vibration or wobbling. A cavity in the
styrofoam packaging has been provided to nest the parts in dur-
ing assembly to assure correct alignment of parts.
Even when the screws are tight, the blades may seem to be
loose. This is normal when using grommets and will not be a
problem.
B.
Insert a mounting screw (provided) in hole in blade bracket.
Use a screwdriver to hold in place. Align blade holes with
mounting holes in hub by turning screw and readjusting blade
bracket until screw mates with threaded hole in hub. Do not
tighten until both screws have been put in blade bracket. Repeat
for all blades. See Figure 10.
C.
A blade balancing kit has been provided with your fan.
Should the fan wobble in operation, you may use this kit to cor-
rect the balance per the instructions supplied with the kit.
NOTE: If a separate wall switch will be used to control a lighting
accessory, connect the black wire with white stripe to the wall
switch lead. The wall switch must be acceptable for use as a
general-use switch.
CAUTION: No bare wire or wire strands should be visible after
making connections.
B.
After making the wire connections, the wires should be
spread apart with the white and green wires on one side of the
outlet box, and the black and black/white wires on the other side
of the box.
The splices should be turned upward and pushed carefully up into
the outlet box.
Step 8: Finish Fan Assembly
A.
The ceiling plate has (3) mounting screw holes located on
the side. Install (2) #10-32 x 1/2" Phillips round head screws
halfway into two of these holes. See Figure 8.
Remove the fan from the ceiling plate hook. Make sure not to
break any wire connections. The canopy has (2) mating slots and
(1) mating hole. See Figure 8.
B.
Position (2) slots in canopy directly under and in line with
(2) mounting screws in ceiling plate. Lift fan until ceiling plate
mounting screws are seated in bottom of slots in canopy. Rotate
fan counterclockwise until both mounting screws drop into slot
recesses. Tighten screws securely. Install third screw into mount-
ing hole.
CAUTION: Failure to securely assemble the canopy screws
could result in the fan falling.
NOTE: For the ball hanging fan configuration make sure the
groove in the ball is engaged with the tab in the canopy. Failure
to do so could result in the fan falling. See Figure 7.
Step 9: Fan Blade Assembly, Installation,
and Balancing
A.
Attach blades to blade brackets using three screws for each
blade. See Figure 9. If your blades have large holes, you must
first insert the rubber grommets into the holes. See Figure 9A.
FORM NO. 41201-01 1/95
- 4 -
©1998 HUNTER FAN CO.
BLADE
GROMMET
NOTE: MAKE CERTAIN ALL
SCREWS ARE TIGHT
BLADE MOUNTING
SCREWS
CEILING PLATE
MOUNTING SCREWS
MOUNTING HOLE
CANOPY
MOUNTING SLOTS (2)
Figure 8
Figure 9
Figure 10
Figure 9A
