©2012 Hunter Fan Co.
7
MISTING RING INSTALLATION
OPERATION AND ADJUSTMENTS
GRILL ASSEMBLY (CONTINUED)
Figure 5
Figure 4
Install the Misting Ring (A) using the three clips attached to the Misting Ring. It should be installed near the center of
the Front Grill (B). While holding the Misting Ring in place, snap the three Clips (aa) directly onto the Front Grill. The
clips should be arranged on the Misting Ring so that they are at the top, far left, and far right. This ensures that the
grooves in the clips will lineup with the wires on the Front Grill. Figure 5.
Off / Speed Selection
- To turn the fan on or adjust the speed setting, use the Fan Speed Knob (H). Turn the knob to
select (III) high, (II) medium, (I) low, or (O) off. Figure 6.
Oscillation
- To allow the fan to oscillate, push down on the Oscillation Knob (I). Pull up on the Oscillation Knob if
oscillation is not desired. Figure 6.
Tilt Adjustmen
t - To adjust the angle the fan is blowing:
1.
Loosen the Tilt Adjustment Knob (K) located on the Motor Housing Pole (L).
2.
Adjust the fan to desired angle, and then retighten the Tilt Adjustment Knob to secure the fan at that angle.
Figure 6
5.
Install the Blade Cap (C) by hand-tightening in a counter clockwise direction.
6.
Place the Front Grill (B) against the Rear Grill (E) so that the Hunter logo faces right side up and push together until
the tabs at the top and bottom of the grills hold them together.
7.
Remove the pre-installed screw from the bottom tabs (ff) on the Grill Ring (F). Slide the Grill Ring over the front and
back grills turning the ring so that the tabs are at the bottom. Reinstall the screw through the holes in the tabs. Hand
tighten in a clockwise direction until the Grill Ring is secure. Figure 4.
8.
Straighten the Power Cord (M) from the Motor Housing (J) along the pole and snap the Cord Clip (T) over the Power
Cord onto the pole so that the Power Cord rests in the notch on the Cord Clip.
H
K
I
aa
A
0
I
II
III
F
ff
